Sign in Request access

Home · Migrations · ArubaOS to Juniper JunOS

Switch migration / Scope first

ArubaOS
to Juniper JunOS

Translate an ArubaOS switch configuration toward Junos for the supported switch scope. ArubaOS is source-only. This is a switch path, not a Junos router path, and not a Cisco IOS-XE switch to JunOS path.

Discuss this migration →Compare migration paths →

Account approval and feature support apply. A listed migration path does not certify every model, version or configuration.

The short answer

Is there a direct Cisco switch to Junos switch migration?

No. The supported-vendors page says there is no direct Cisco IOS-XE switch to JunOS switch path. Juniper switch configurations translate to and from Aruba CX, and from ArubaOS. Router translation between IOS-XE and Junos is a different pair of guides.

Define the handoff

What goes in.
What you review.

Source inputs

An ArubaOS switch configuration. ArubaOS is source-only.

Target output

A Junos switch candidate for VLANs, trunking, aggregated Ethernet and Layer 3 interfaces in the supported scope. The result stays in NEEDS REVIEW.

Path-specific boundaries

Juniper SRX was removed as a firewall target. ScreenOS and older Junos 11–12 are not this path.

Scope the review

Check the behavior,
not just the syntax.

REVIEW 01

VLANs and trunks

Confirm VLAN and trunk mapping into Junos interface units or ethernet-switching, as the findings describe.

REVIEW 02

Aggregated Ethernet

Review AE interfaces against the ArubaOS trunks. IDs may be renamed so they fit the target.

REVIEW 03

Layer 3

Review IRB or VLAN interfaces that are in scope. Missing addresses stay findings.

REVIEW 04

Held for review

Every hosted switch result stays in NEEDS REVIEW even after the emitted text is checked. Engineers test the device before any change.

Each result's status comes from deterministic checkpoints (CP0–CP4) and, on firewall paths, behavior checks (BC1–BC4); AI can explain findings but never sets status. These are review areas, not a guarantee that every construct in them is automated. Unsupported features, missing captures and conditional behavior remain part of the engineering review.

Every hosted router and switch result is held in NEEDS REVIEW for engineer review, even after the emitted configuration text is checked.

Questions

Common questions

Can this page target a Junos router?

Use the router guides for IOS-XE and Junos routers. This page is the ArubaOS switch to Junos switch scope.

Is ArubaOS written as output anywhere?

No. ArubaOS is source-only.

What status will the job show?

Every hosted router and switch result is held in NEEDS REVIEW for engineer review, even after the emitted configuration text is checked. AI can explain findings but never sets status.

Plan the next step

Bring the details
that make your migration different.

Bring the ArubaOS version and whether the Junos device is a switch. Do not send an SRX firewall here.

Discuss your scope →Junos to Aruba CX →